Hitec D950TW D-Series Ultra Torque Titanium Gear Servo

For 20-120 class aircraft, all EP 600-700 class helicopters, all
GP 30-90 class helicopters, 1-10-1/4 scale vehicle steering and
throttle, and nitro and gasoline powered boats
Durable titanium alloy metal gears with dual ball bearings
Ultra hard gear shaft with three axial metal bushings
32-bit MCU and 12-bit ADC for unprecedented programmability and
flexibility
*Programmable digital amplifier with MOSFET drive
Water and dust resistant (splash proof)
Metal center heat sink

D-950TW Wide Voltage Ultra Torque Servo
0.98" (25mm) Single Arm
1.7" (44mm) Double Arm
1.5" (38mm) 4-Point Horn
1.4" (36mm) Round Horn
Four each Grommets, Eylets and Mounting Screws
Metal Adapter Ring, extra Horn Screw

4.8V 6.0V 7.4V
Speed: 0.23 0.17 0.14 sec/60°
Torque: 291.632 402.73 486.05 oz-in
21 29 35 kg-cm
Motor Type: Coreless
Dimensions: 1.57 x 0.79 x 1.50" (40 x 20 x 38mm)
Weight: 2.40 oz (68.0g)
Number of Teeth on Spline: 25
Diameter of Horn Screw: 3mm

*Programmable features require Hitec Servo Programmer sold separately
HFP-30, DPC-11, HRCP4429

A note on Coreless motors: conventional servo motors have a steel
core armature wrapped with wire that spins inside the magnets. In
a Coreless design, the armature uses a thin wire mesh that forms a
cup that spins around the outside of the magnet eliminating the
heavy steel core. This design results in smoother operation and
faster response time.