Vortex 285

.

In most serious crashes, the parts in Crash Kit #1 (Plastic Parts) will suffice to get the Vortex in the air again. For the real serious stuff, parts from Crash Kit #2 (Carbon Fiber Parts) may be required.  Contains the following...

ImmersionRC video transmitter specially designed for  Vortex 250 / 275 / 285. The power can be adjustable from 1 to 600mW.FEATURES:Hardware V2Smallest direct LiPo powered vTx in the business.TNR Touch-free wand control1mW -> 600mW+ linear power...

Key Features Vortex Power Distribution Board, Replacement PCB. Overview The Power Distribution Board forms a 'sandwich' with the upper Carbon Fiber plate to make up the Vortex frame. A powerful 3A 5V BEC provides ample power for the rear...

Key Features An updated anti-jello plate for the Vortex, which inclines the Mobius by 20 degrees, for optimal camera angle when flying at speed. Overview Includes: 1x Baseplate (Carbon Fiber) 1x Top Plate (Carbon Fiber) ...

 This is a replacement for the black OEM T-Motor used on the Vortex 285. Integrated prop shaft, and M5 CW Nyloc nuts.

.

Key Features Interface cable to allow a Spektrum(tm) Satellite receiver to be connected directly to the Vortex PDB Overview This neat little cable houses a 32-bit ARM processor which handles the conversion between the Spektrum serial...

.

These are parts most likely to break in a serious crash with the Vortex.  Included are all parts which mount the motors to the carbon fiber arms, the plastic pivot points, foldable arm clips, and all other plastic parts.  No carbon...