HoBao Racing HB-MT-C30DG 1/8 RTR Hyper MT Sport Plus Nitro w/HT-2.4EF Radio Gray

Chassis: Aluminum, monocoque design
Drive: Four wheel shaft
Transmission: Heavy duty 2-speed, fully adjustable
Differentials: Front, center and rear with steel gears
Engine: Hobao Hyper 30 with slide valve carb, Hobao T5 turbo platinum glow plug, and large plastic pull-start handle, two-stage foam air filter
Exhaust: Aluminum tuned pipe with polished natural finish
Radio: HoBao HT-2.4EF 3-channel 2.4GHz FHSS with dual rate steering and throttle, charge jack on transmitter for optional NiCd batteries, high output digital steering and throttle servos
Servos: HoBao HB 5514 waterproof, metal gear, ball bearing equipped digital servos, 194oz-in (14kg-cm) torque
Suspension: Front and rear lower composite suspension arms, front and rear stabilizer bars
Shocks: Oil=filled aluminum body super stroke
Shock Towers: Composite plastic
Fuel Tank: 8.4oz (250cc)
Clutch: Three shoe composite, 14 tooth steel clutch bell
Spur Gear: 32 tooth steel
Tires: Off-road, rubber construction with foam inserts 7.2" (182mm) diameter, 3.8" (96mm) wide
Wheels: Six spoke, gray in color, 17mm hex
Body: Trimmed and painted in gray with red, black, white and yellow color scheme
Brake: Dual disc
Ball Bearings: Full set, rubber sealed
Caster: Adjustable front and rear, caster/toe-in refers to the angle of the suspension when viewed from the side of the car in relation to the chassis
Camber: Adjustable front and rear, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle

RTR Hyper MT Sport Plus Monster Truck with .30 cu in (4.9cc) Engine, 3-ch Radio, Steering and Throttle Servos, Decal Sheet, Body, Air Filter and Instruction Manual

AA Batteries: Twelve, 8 for radio, 4 for receiver
Nitro Fuel: Car blend with 15-30% nitro content, 30% required for engine break-in
Maintenance equipment

Vehicle;
Length: 22" (560mm)
Width: 18.5" (470mm)
Height: 10.2" (260mm)
Wheelbase:
Weight: 10.9lbs (4960g)

Body;
Length: 19.4" (492mm)
Width: 7.3" (185mm) at widest point
Height: 5.3" (134mm)

Carburetor Needle Settings;
Factory Default After Break-In
Top End (high speed): 3 turns out 2-1/2 turns out
Bottom End (low speed) 1/4 turn out flush w/ball collar
Mid Range: Flush-do not touch Flush-do not touch
Idle Screw 1mm (1/16" ) 1mm (1/16" )