Tekin TT2732 RPM Gen3 Brushless Sensored 17.5T Motor & RS Gen2 Brushless ESC

TT2704 RPM Motor (TEKC2704);
RPM version designed for applications where higher RPM is more
benefical than torque
Ideal for 1/12 and touring car racing classes
CNC machined T 6061 billet aluminum heat sink can
For on- or off-road use
12.5mm performance rotor
Dual-plug sensor wire harness for all sensored and sensorless systems
Anodized end-bell plates maximize corrosion and wear resistance
High RPM precision ball bearings
Neodymium sintered magnet
Rebuildable
Adjustable timing
Low resistance solder tabs
Solderless sensor PCB replacement

ESC;
Compatible with sensored, sensorless, brushless, and brushed motors
Datalogging capability
High voltage programmable Battery Eliminator Circuit (BEC)
HotWire PC interface for advanced programming and updating, EZ access
programming port (HotWire Interface (TEKM1450), and Gen 2 Adaptor
(TEKM3825) required)
Forward, brake, and reverse operation
D2 Dual Drive Mode technology
On-board temperature indicator
Sensor plug for precise commutation with all motors
Gold plated solder posts
Pit tune mode
HDAC: High Density Copper PCBs
Self test diagnostics and factory reset
DGF2 Digital Glitch Filtering V2
QuickTune programming with one-touch radio calibration
120 day limited warranty through Tekin beginning at date of purchase

RS Gen 2 Spec D2 Brushless ESC with Instructions, Motor and Receiver
Wires
Redline GEN3 17.5 Turn RPM Brushless Sensored Motor with Sensor Wire

ESC;
Input Voltage: 4-9 cells, 2-3S LiPo
BEC: 6.0V / 7.4V @ 5.5A
Motor Limit Brushless Mode 2S: 8.5T 2-Pole 36mm Can
Motor Limit Brushless Mode 3S: 10.5T 2-Pole 36mm Can
Motor Limit Brushed Mode 2S: 12 Turn 36mm Can
Motor Limit Brushed Mode 3S: 20 Turn 36mm Can
Max Current: 120amps per phase
Max Chassis Weight: 4lbs (1815g)
Throttle Profiles: 7 choices on-board
Brushed Modes: Fwd Only, Fwd/Rev, Rev Delay
Brushless Modes: Fwd Only, Fwd/Rev, Rev Delay
Dimensions: 1.0 x 1.3 x .51" (26 x 34 x 12.9mm)
Weight: .85oz (24g)
17.5T RPM Motor;
Input Voltage: 2S all, 3S-10.5 and up
Shaft Dimensions: 3.2mm (1/8") x 15.3mm
Weight: 5.6oz (158g)
Motor Diameter: 1.40" (35.85mm)
Motor Length: 1.9" (48.5mm)
Bearing Dimensions: Front: 4x13x5mm / Rear: 1/8x3/8x5/32"
Rotor Size: 12.5mm