Tekin TT2743 Gen3 Brushless Sensored 17.5T Motor & RS Gen2 Spec D2 Brushless ESC

This is the Tekin RS5 Gen 3 Brushless Sensored 17.5T Motor and the RS Gen2 Spec Brushless Electronic Speed Control.

FEATURES
TT2705 17.5T Motor (TEKC2705);
CNC machined T 6061 billet aluminum heat sink can
For on- or off-road use
12.5mm performance rotor
Dual-plug sensor wire harness for all sensored and sensorless systems
Anodized end-bell plates maximize corrosion and wear resistance
High RPM precision ball bearings
Neodymium sintered magnet
Rebuildable
Adjustable timing
Low resistance solder tabs
Solderless sensor PCB replacement

ESC (TEKC1155);
Compatible with sensored, sensorless, brushless, and brushed motors
Datalogging capability
True ROAR spec mode only, no timing or boost features available
High voltage programmable Battery Eliminator Circuit (BEC)
HotWire PC interface for advanced programming and updating, EZ access programming port (HotWire Interface (TEKM1450), and Gen 2 Adaptor (TEKM3825) required)
Forward, brake, and reverse operation
D2 Dual Drive Mode technology
On-board temperature indicator
Sensor plug for precise commutation with all motors
Gold plated solder posts
Pit tune mode
HDAC: High Density Copper PCB's
Self test diagnostics and factory reset
DGF2 Digital Glitch Filtering V2
QuickTune programming with one-touch radio calibration

INCLUDES
RS Gen 2 Spec D2 Brushless ESC with Instructions, Motor and Receiver Wires
Redline GEN3 17.5 Turn Brushless Sensored Motor with Sensor Wire

SPECIFICATIONS

ESC;
Input Voltage: 4-7 cells NiMH/NiCd, 2S LiPo
BEC: 6.0V / 3.7V
Amperage: 60A per phase
Motor Limit Brushless Mode 2S: 13.5T 2-Pole 36mm Can
Motor Limit Brushed Mode 2S: 20 Turn 36mm Can
Max Chassis Weight: 4lbs (1815g)
Throttle Profiles: 7 choices on-board
Brushed Modes: Fwd Only, Fwd/Rev, Rev Delay
Brushless Modes: Fwd Only, Fwd/Rev, Rev Delay
Dimensions: 1.0 x 1.3 x .51" (26 x 34 x 12.9mm)
Weight: .80oz (22.5g)

17.5T Motor;
Input Voltage: 2S all, 3S-10.5 and up
Shaft Dimensions: 3.2mm (1/8") x 15.3mm
Weight: 5.6oz (158g)
Motor Diameter: 1.40" (35.85mm)
Motor Length: 1.9" (48.5mm)
Bearing Dimensions: Front: 4x13x5mm / Rear: 1/8x3/8x5/32"
Rotor Size: 12.5mm