Castle Creations 1520-1650KV Sensored Brushless Motor : 1/8 - 1/6 Vehicles

Technical Specs
Application: The 1520-1650kV motor is intended for use in 1/6, 1/7 and 1/8 scale vehicles weighing up to 18 lbs. and running up to 8s LiPo. Examples include Losi LST2-E™; Arrma™: Limitless™, Typhon™ 6s, Kraton 6s™, Kraton EXB™, Infraction™ Felony™ 6s, Notorious 6s™, Talion™ 6s; Kyosho Inferno™, Traxxas: E-Maxx™, E-Revo™, UDR™, Summit™; Redcat Shredder™  Note: "Recommendations based on vehicle weight and motor capabilities. Verify motor fitment, may require optional motor mount."
Max Weight:: 18lbs
Input Voltage: 3s-8s
Kv: 1650
Max RPM: 60,000
Size: Diameter: 1.64" (41.6mm) Length: 3.50” (88.8mm)
Weight (with wires): 508g (17.92 oz); 459g without wires
Shaft Size: 5mm
Mounting Hole Specifications: M3 and M4 @ 25.4mm (1.0") Diameter
Running Modes: SmartSense™ Sensored and an ultra-efficient Sensorless mode
Connectors: 6.5mm male connectors and 10AWG wire
Items Needed for Operation: Compatible Electronic Speed Control. We recommend Mamba Monster X 8S.
Product Use Statements: Monitor motor temperatures closely; overheating a motor will cause permanent damage to the magnets. Never exceed 180° F on the the motor or ESC. Do not use mounting screws that extend more than 5mm into the front of the motor. Using too long of a screw can result in damage to the motor's windings and will not be covered by the warranty.
Tech Notes: The 1520-1650Kv is a water resistant design. The sensor board is coated with silicone conformal coating to protect the sensors from moisture. The sensor connections are not water resistant; water can cause signal loss which could result in loss of sensored capabilities. We recommend applying dielectric grease to the outside of the sensor wire connections after installation of the wire. Routine maintenance is recommended after running in wet conditions. Please refer to this document for running and maintaining motors in wet environments.