ARRMA AR390211 BLX185 6S 150A ESC Electronic Speed Control

 This is the Arrma BLX185 6S 150A Electronic Speed Control.

FEATURES:
Can be powered by two 3-6S (11.1-22.2V) LiPo batteries, 35C 5000mAh minimum requirement
6.0V/3A continuous output, 12A max
Bridge connector for using single 4S or 6S battery
Over voltage and overheat protection
Two stage LiPo cutoff, single stage NiMH cutoff
Temperature protection mode if ESC temperature exceeds 221°F (105°C)
Integrated cooling fan to reduce heat during extreme running
Waterproof under normal usage
Integrated hold down tabs easily secure inside vehicle chassis
Set up for use from factory, settings may be changed

INCLUDES

BLX185 6S ESC with Cooling Fan, two Amass XT90 Battery Connectors with 10AWG Wires, Receiver Plug, Power Switch and Set Button
10AWG Motor Wires with 4mm Diameter Gold Plated Female Connectors, Instructions and Bridge Connector

REQUIREMENTS

Motor such as the Arrma BLX 2050Kv 6S Brushless Motor, AR390205

SPECIFICATIONS

Length: 2.26" (57.5mm)
Width: 2.34" (59.5mm) including hold down tabs
Height: 1.53" (38.9mm)
Weight: 6.9oz (196g)
Switch Length: 1.15" (29.3mm)
Switch Width: 0.5" (12.8mm)
Switch Height: 0.71" (18mm)
Receiver Wire Length: 7.87" (200mm)
Battery Wire Length: 6.5" (165mm)
Motor Wire Length: 5.12" (130mm) including connector
Motor Limit: 3000kV
Wire Size: 10AWG
Motor Connectors: Gold bullet
Battery Connectors: Two Amass XT90
BEC Voltage: 6.0V
BEC Current Minimum Continuous: 3A
BEC Current Max Burst: 12A
Low Voltage Cutoff: 3.2V
Over Voltage Protection: Over 6S LiPo (22.2V)
Continouous Amp Rating: 150A
Throttle Mode: FWD/BRAKE/REV
Throttle Setup: Manual via pushbutton
User Programmable: Yes, via button only
Battery Mode: LiPo/NiMH, default LiPo mode