Traxxas

FEATURES: Metal construction Five cooling holes on the face of bell (bellow the teeth)INCLUDES: One clutch bellTwo washersTwo e-clipREQUIRES: This clutch bell uses 5X11 bearings #4611 (not...

FEATURES: Vented clutch bell One piece bell design INCLUDES: One 15 tooth black vented clutch bell Two 5x8x0.5mm fiber washers One 5mm e-clip REQUIRES: Using the original 5x11x4mm clutch bell ball...

FEATURES: Metal construction Five cooling holes on the face of bell (bellow the teeth) INCLUDES: One clutch bell Part #5214 Two washers Part #1985 Two e-clip Part #1633 REQUIRES: This clutch bell...

This is the Traxxas 2.5R Racing Engine with IPS (Integrated Pilot Shaft) and Pull-Start.For use in all Traxxas vehicles that use the TRX 2.5 engine.This engine is a .15 engine. The 2.5 refers to a...

.

.

 Fits Continued: 1/10 Monster Mutt / Ford Raptor / Slash R.G.D. / Nitro Jato 3.3 / Revo / T-Maxx FEATURES: Constructed of rubber, black in color with with "TRAXXAS" written in white on the...

These are the 5182A 20 x 27 x 4mm Ball Bearings for the Traxxas X-Maxx Monster Truck     FEATURES Steel construction with black rubber...

FEATURES: Holds all gears including the 2speed gear set and input shaft Gray in color, constructed of hardened plastic Fits front or rear of vehicle INCLUDES: One each Front and Rear Gearbox Halves,...

Ball bearings, black rubber sealed (6x13x5mm) (2) Replacement part for these models: TRX-4 Assembly Kit TRX-4 Ford Bronco TRX-4 Scale and Trail Crawler TRX-4 Tactical Unit Unlimited Desert...

FEATURES: Stainless Steel bearing construction Blue rubber dirt shields INCLUDES: (2) 6x13x5mm ball bearings Part #5180 SPECS: Inside diameter: 6mm (0.24") Outside diameter: 13mm (0.51") Width: 5mm...

FEATURES: Steel construction Silver in color INCLUDES: Two 59mm screw pins. Four 73mm screw pins. Two 65mm screw pins.

FEATURES: Holds receiver and Optidrive Shift Module in place Two piece, gray in color, constructed of hardened plastic INCLUDES: Receiver Box and Body Clip, 3935 REQUIRES: Fastening to chassis,...

FEATURES: Black plastic construction INCLUDES: One sensor cover (one black plastic plastic construction) One black plastic cover (covers the spot that the optidrive was) One blue rubber...

FEATURES: Steel construction Can be used to replace a bent or damaged front center driveshaft INCLUDES: One steel constant-velocity driveshaft REQUIRES: Dust boots and pins(TRAC5129) SPECS: Length:...

FEATURES: Steel construction INCLUDES: Two steel constant velocity driveshafts Two M4/15 screw pins REQUIRES: Installation onto vehicle. SPECS: Length: 18mm (.70") Diameter: 13mm (.51")

FEATURES: Black plastic construction Pre-installed pressure fitting INCLUDES: One Tuned Pipe for the Traxxas T-Maxx. REQUIRES: Nothing. This is a direct replacement part. SPECS: Length: 114mm (4.49")...

Features:Constant-Velocity Driveshafts are designed to handle Extreme Horsepower and Articulation.Inner and Outer U-joints are Lubricated and Sealed by a Rubber Boot for maximum protection against...

.

FEATURES: Aluminum Construction Silver in Color INCLUDES: Four Aluminum Wheel Spacers REQUIRES: Assembly onto Vehicle