Traxxas

FEATURES: Black plastic construction INCLUDES: Two Gearbox halves (Front and Rear) One 40mm Guide Pin Five 3x12mm Roundhead Self-Tapping Screws Two Idler Gear Shafts One Idler Gear Shaft Support REQUIRES: Remainder of the gearbox contents. SPECS: Length:...

FEATURES: Black plastic construction INCLUDES: Gearbox halves (front and rear) and screws REQUIRES: Remainder of the gearbox contents SPECS: Length: 2.67 (68mm) (at widest point) Width: 3.42" (87mm) (at widest point)

FEATURES: Steel shaft, black in color Steel drive gear assembly, silver in color INCLUDES: One Input Shaft with 18 Tooth Top Gear REQUIRES: Installation following the model manual SPECS: Shaft Diameter: 5mm Shaft Length: 3.53" (90mm) Thread Size: 4mm

  FEATURES: Aluminum construction, blue anodized INCLUDES: One motor plate REQUIRES: Installation on the E-Maxx truck SPECS: Width: 3.58" (91mm) (At widest point) Height: 2.75" (70mm) Thickness: .11" (3mm)

FEATURES: Aluminum construction, blue in color Designed for a clean install of a single brushless motor system in the E-Maxx 16.8V RTR (requires gear cover number 3997 (not included))INCLUDES: One Aluminum Motor PlateREQUIRES: Installation and motor...

Backplate (for .15 recoil)

FEATURES: Plastic Construction Black in color Molded-in servo mounts INCLUDES: One Plastic Chassis REQUIRES: Item is a stock replacment part. SPECS: Length: 241mm (9.5") Width: 101.5mm (4") COMMENTS: Original screws are needed for assembly.

FEATURES: Plastic Construction Grey in color Molded-in servo mounts INCLUDES: One Plastic Chassis REQUIRES: Item is a stock replacment part. SPECS: Length: 241mm (9.5") Width: 101.5mm (4") COMMENTS: Original screws are needed for assembly.

This is an optional Large Knurled Flywheel for use with Starter Boxes. FEATURES: Large knurles to be gripped by rubber starter wheels Two pin aluminum construction Vent holes drilled to keep clutch shoes cooler INCLUDES: One 40mm flywheel REQUIRES:...

4261T Hardened Steel, Titanium Nitride-coated Shock Shafts (29mm) These hardened, ground steel shafts have a super tough titanium nitride coating with a micro-polished finish that reduces stiction for smoother performance and resists scratching for much...

FEATURES: Hardened steel and titanium nitride coated (Brass color) INCLUDES: Two shafts REQUIRES: Installation in shock bodies SPECS: Diameter: 3mm (0.118")_ Length: 32 mm (1.26") Thread: 3mm (0.118") COMMENTS: Uses 3mm e-clips

FEATURES: Composite plastic construction, black in color Supports fuel tank and helps to staabilize chassis INCLUDES: Upper Composite Chassis Section