Traxxas

FEATURES: Steel construction Rubber sealed INCLUDES: Two Ball Bearings REQUIRES: Installation on the vehicle SPECS: Outer Diameter: 27mm (1.06") Inner Diameter: 20mm (0.79") Width: 4mm (0.16")

These are the 5182A 20 x 27 x 4mm Ball Bearings for the Traxxas X-Maxx Monster Truck     FEATURES Steel construction with black rubber seals Used as the inner bearing in the front steering...

FEATURES: Constructed of foam and pre-oiled to trap dirt Pre-Filter for extra filtration INCLUDES: Three Air FIlter Inserts for the Traxxas 3.3 engine SPECS: Height: 38mm (1.5") Diameter: 38mm (1.5")

The aluminum backplate replaces the EZ-Start drive unit on the TRX 2.5, TRX 2.5R, and TRX 3.3 Racing Engines. It allows more efficient fuel/air mixture flow through the crankcase and significantly reduces overall engine weight. It's perfect for building...

FEATURES: Black plastic construction Accomodates either AA battery holder or RX flat pack INCLUDES: One receiver box with cover One battery box with cover Rubber charge jack plug Foam pad and adhesives Mounting hardware REQUIRES: Installation on the...

FEATURES: Nylon Construction Black in Color Allows for Oversized Bearing use INCLUDES: One Left Axle Carrier One Right Axle Carrier Four Dust Boot Retainers Two Bearing Spacers REQUIRES: Installation

  FEATURES: Plastic Construction, Black Chrome in Color INCLUDES: One Front and one Rear Bumper REQUIRES: Installation SPECS: Front Bumper Rear Bumper Length: 104mm (4.09") Length: 116mm (4.57") Width: 24.4mm (0.96") Width: 25mm (0.98")

FEATURES: Steel turnbuckle design 5.0mm diameter INCLUDES: Two front or rear toe links REQUIRES: Nothing. These are direct replacement parts. SPECS: Length: 5.1" (129mm)

FEATURES: Black and grey plastic construction INCLUDES: Four throttle servo horns (Airtronics/Sanwa, Hitec, KO Propo/Fut, JR) Eight steering servo horns for the above mentioned radio brands REQUIRES: Nothing. These are direct replacement parts. COMMENTS:...

Fits Continued: 1/10 Slash R.G.D. / Rally VXL / Nitro Slash / Revo / T-Maxx / Slayer Pro 4x4 / T-Maxx Classic FEATURES: Aluminum construction, blue anodized in color INCLUDES: Four aluminum splined wheel nuts REQUIRES: Installation on the vehicle  

Fits Continued: 1/10 Slash R.G.D. / Rally VXL / Nitro Slash / Revo / T-Maxx / Slayer Pro 4x4 / T-Maxx Classic FEATURES: Aluminum construction, green anodized in color INCLUDES: Four aluminum splined wheel nuts REQUIRES: Installation on the vehicle

FEATURES: Constructed of 0.12" (3mm) thick 6061 T-6 aluminum Anodized blue in color INCLUDES: Chassis Brace and 4x16mm hex head screw REQUIRES: Installing on left side of chassis underneath engine