DB10

The 'bullet proof' rear motor gear box for the RB10, PRO2-SC10 and DB10. Heavy duty machined alloy gearbox that keeps your gears in perfect alignment, your slipper and motor cooler and the wheelie bar pointed straight.Direct bolt on and weighs 43gr.

Heavy duty machined 7075 alloy steering hub set for the RB10, PRO2 SC10 and DB10.Great addition to you car that provides extra durability and precision to your front wheels and steering action.Also helps reduce the 'bump steer' found on the stock hubs by...

Heavy duty design maintains your suspension geometry setting, race after race.Our updated design works as either the left or right hub (hubs are non-directional) and also allows for adjusting the wheelbase as needed using the supplied spacers.The upright...

Heavy duty steering crank set for the RB10, PRO2 SC10 and DB10 trucks and buggies. The servo ball mount is reinforced to resist bends seen in other brands cranks. Gives you a more direct steering feel with less steering bounce.Also the servo crank...

Heavy duty machined 7075 alloy differential case for the RB10, PRO2 SC10 and DB10 (NOT for the B6).Perfect machined roundness makes for a free spinning transmission and a must have for high powered drag racing applications.This is much stronger than the...

Heavy duty 11gram 7075 alloy bulkhead for the RB10, PRO2 SC10 and DB10.Great looking and solid mounting of your front suspension. Includes set screws to hold the hinge pins.Use blue thread and do not over tighten hardware.

Heavy duty 7075 alloy rear suspension mount (D) for the RB10, PRO2 DC10 and DB10.Stronger construction insures race finishes, even after hard impacts, so that you drive more and wrench less.Tapered hinge pin opening insures easier installation and...

Heavy duty 1 piece alloy servo mount for the RB10, PRO2 SC10 and DB10.Makes for easier servo install and removal thanks to the 1 piece design that will always match the chassis holes.

Heavy duty steering rack for the RB10, PRO2-SC10, DB10.Precision machined, polished and anodized in team AE blue for that factory racing look.

Our ultralight direct spur gear mount for the RB10, PRO2-SC10 and DB10.Machined alloy unit that weighs only 3.4gr with the screws.Uses a wider range of available spur gear sizes by Exotek, Kimbrough, etc.Allows for easy switching between a locked spur or...

Hard anodized 7075 alloy idler gear for the RB10, PRO2 SC10 and DB10.Must have for high powered applications.This is much stronger than the stock plastic idler gear but not indestructible so it is important to use black or white grease on the gears and...

Precision machined heavy duty alloy rear clamping hex set designed just for the  RB10, PRO2 SC10 and DB10.Looser steel cross pin tolerance allows you to tighten the wheel nuts without binding the bearings. The hexes do not lock onto the bearings,...