RC Lights RCL106A 6 LED Lights Add-On For Rpm Roof Canisters (3mm, 14)

Key Features

Overview

This is your no-solder LED lighting solution for RPM Light Canisters & RPM Tail Lights!   Use RCL106A to add 6 3mm white LED lights to RPM Roof Canisters to any controller with 6 extra constant LED channels (see RCL104). Add-On for RCL104 to make a 10 LED System.

Compatible with RPM Roof-Mounted Light Bar Set RPM80922, RPM80923 & RPM80925 --Direct fit for Slash 4x4, Slash & SC10.  To change LED sizes or colors use 5mm or 3mm LEDs.

This system add-on requires a LED controller and power source. Add-On for RCL104.

If not used with RCL104 use with Standard 10 LED Controller RCL5051 or any other LED controller with available channels.

Includes:
Instruction Set -
(6) 14" wire extensions       RCL539014
(6) 3mm white LEDs           RCL5280W 
(6) 2P connector housings 
(2) zip ties                         RCL5080

Specs:
TOTAL LED CURRENT DRAW (@6V): 110mA
(A standard servo draws approx. 350mA)

Blue, Green, White, White Strobe, Red Strobe LEDs
FORWARD VOLTAGE: 3.2V
MAX CURRENT: 30mA

Amber, Red LEDs
FORWARD VOLTAGE: 1.9V
MAX CURRENT: 30mA

DIY HOBBYISTS: If connecting LEDs directly to power a current limiting resistor must be installed on each LED or it will blow and void the warranty. (160 ohm @ 6V)

*Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

*DO NOT look directly into beam.