RC Lights RCL5056 Nightfly 14 LED Lights Controller : RC Heli / Airplane

Overview

Directly power up to 14 LEDs. Current limiting resistors are built right in.

Using the NIGHTFLY 14 LED Controller, LEDs can be directly powered from the RX or an additional power source.

LEDs are split into five banks: 4 constant; 4 switched on/off depending on TX 2-pos switch position (Landing Lights); 2 fully-adjustable single strobes; 2 fully-adjustable single/double strobes; and 2 simulated rotating beacon lights (adjustable fast/slow).

The NIGHTFLY 14 LED Controller has two TX/RX signal inputs; one is for switching auxiliary (landing) lights on/off; the second is for switching power to the entire controller on/off. Each signal input should be plugged into an available RX channel tied to a 2-position switch on the TX. A Y-harness or RX Pass-Thru can be used on channels in use, but still provide the correct signals for switching (i.e. landing gear channel).

Link additional controllers using the extra set of PWR & AUX inputs.

Included Items:
Instruction Set
(1) NIGHTFLY 14 LED controller
(1) 2-Channel RX Plug
(2) zip ties & bases

Specs:
DIMENSIONS: 1.65" x 1.0" x 0.25"

INPUT VOLTAGE: 3.6-7.4V [6V Optimal]

TYP OUTPUT CURRENT (per LED channel): 20-30mA

Controller pins can be directly soldered to for DIY projects. Use heat shrink to insulate each pin.

*Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

*DO NOT look directly into beam.