RC LIGHTS
RC Lights RCL5057 Nightfly2 14 LED Lights Controller : RC Heli / Airplane
- SKU:
- RCL5057
- UPC:
- 813487010888
- Condition:
- New
Description
Overview
Directly power up to 14 LEDs. Current limiting resistors are built right in.
Using the NIGHTFLY2 14 LED Controller, LEDs can be directly powered from the RX or an additional power source.
LEDs are split into six banks: 4 constant; 2 landing lights switched
on/off depending on TX 2-position switch; 2 fixed-rate 1Hz single
strobes; 4 fully-adjustable alternating strobes (2 Left & 2
Right); and 2 simulated rotating beacon lights (adjustable fast/slow).
The NIGHTFLY2 14 LED Controller has two TX/RX channel inputs; one is
for switching power to the entire controller on/off, and the second is
for switching auxiliary (landing) lights on/off. Each channel input
should be plugged into an available RX channel tied to a 2-position
switch on the TX. A Y-harness or RX Pass-Thru can be used on channels
in use, but still provide the correct signals for switching (i.e.
landing gear channel). The NIGHTFLY2 14 LED Controller provides
extensive adjustability to the alternating strobes allowing for single,
double, triple, single/double, double/triple, or simulated machine gun
lighting effects. Beyond that the timing between individual strobe
flashes can be adjusted fast/slow and the timing between the left and
right alternating banks is fully-adjustable. Landing lights and single
strobe banks can be disabled so that it becomes 8 fully-adjustable
alternating strobes (4 Left & 4 Right) and the second auxiliary
channel input switches the alternating strobes on/off, perfect for
warbird applications with simulated machine guns. Additionally, the
TX/RX channel inputs can be simple on/off or multi-mode can be enabled.
When multi-mode is enabled each flip of the switch performs a
sequential action. The master power channel input defaults to all off,
flip once and the constant navigation turn on, flip again and the
rotating beacon comes on, flip again and all strobe lights turn on,
flip again and the landing lights light, flip again and everything
turns constant on for an easy landing or testing purposes, and a final
flip turns everything back off. If the second auxiliary channel is
present it will either engage/disengage the landing lights, or if they
are disabled the alternating strobes, with the all-on mode following,
along with a back off with another flip. The NIGHTFLY2 14 LED
Controller is by far our most feature packed controller which is why
you will want to be sure to add one to your R/C aircraft today!
Link additional controllers using the extra set of PWR & AUX inputs.
Included Items:
Instruction Set
(1) NIGHTFLY2 14 LED controller
(1) 2-Channel RX Plug
(2) zip ties & bases
Specs:
DIMENSIONS: 1.65" x 1.0" x 0.25"
INPUT VOLTAGE: 3.6-7.4V [6V Optimal]
TYP OUTPUT CURRENT (per LED channel): 20-30mA
Controller pins can be directly soldered to for DIY projects. Use heat shrink to insulate each pin.
*Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.
*DO NOT look directly into beam.