Power Supplies / Transformers

Provides circuit protection for up to six sections of your railroad. Operates with any DCC system. Factory set to 1 amp per section. Sections can be connected together for more power per section.

.

Provides short circuit protection for one power district. Can be used with most DCC systems. This is not recommended for use with the Power Cab. For the Powercab use a CP6!

FEATURES: Used in conjuction with the Bachmann® E-Z Command® Walk-Around            Companion.          Multiple connector panels let you...

Low-cost, High-sensitivity DCC block-occupancy detection.Adjustable resistance/current detection section (DS) trip threshold.8A capacity, suitable for all scales and track wiring configurations.Noise resistant and compatible with BDL168 sections.On-board...

The easiest most cost effective way to add automatic reversing to one section of your DCC layout. AR1 Features: Cost effective automatic reversing for one reversing section or subdistrict User selectable...

New power supply for power injection to TCS panels and devices.WARNING:  This product is only intended for use with specific TCS products. TCS does not condone the use of this power supply for other uses than the following:LT-50 (Panel)LCC Throttle...

LocoNet Universal Panel and 3 Amp Z Scale Voltage Reducer6 LocoNet Jacks for use with all scalesReduces track voltage by 4 or 6 volts at 3 amps for safer Z Scale locomotive opreration with Digitrax equipment

DescriptionOutputs DC16V 2.1AIdeal for HO Gauge Layouts

 

Cobalt iP Digital “Intelligent Power” DCC/DIGITAL Point MotorOne Cobalt iP Digital “Intelligent Power” DCC Digital Turnout Motor with all installation accessories including mounting screws and one of our very popular double-sided foam mounting pads...

This is our lowest cost, easiest to use cab bus panel. All four RJ-12 jacks are wired in parallel for easy plug and play use. This board also provides a convenient point to add additional 12 Volt cab bus power, just plug in a 12 Volt "wall wart" power...