RC Lights RCL5053 Deluxbrake, 14 LED Lights Controller : RC Cars / Trucks

Overview

Directly power up to 14 LEDs. Current limiting resistors are built right in.

Using the DELUXBRAKE 14 LED Controller, LEDs can be directly powered from the throttle channel of the RX using the included RX Pass-Thru (mini Y-harness).

Dual intensity brake light action is built right in! Throttle channel input fully reversible.

LEDs are split into five banks: 4 constant/strobing headlights (2 each side R & L; headlight strobe rate fully-adjustable); 4 auxiliary lights switchable from TX/RX auxiliary channel input in multi-mode; 4 switched dim or full bright depending on throttle stick position (GAS or BRAKE); and 2 fully-adjustable intensity fog lights switched from TX/RX auxiliary channel input in multi-mode.

Auxiliary channel input can be used for simple power on/off to the entire controller or multi-mode can be enabled. If enabled the lights will default to all off, flip the TX switch once and the headlights and brake lights will turn on, flip it a second time and everything will turn off, flip it again and the headlights and brake lights will turn on with the auxiliary and fog lights, and flip it once more and everything will turn off.

The DELUXBRAKE 14 LED Controller is a perfect combination of our popular RPS & EBS electronic control switches (remote power and electronic brake switches).

Throttle and auxiliary center-stick auto-detect for precise lighting effects every time.

Full-feature functionality built right in: headlight strobes, multi-action auxiliary lighting switching, adjustable intensity fog lights, and dual intensity brake lights for the ultimate in scale lighting effects for any R/C vehicle.

Included Items:
Instruction Set
(1) DELUXBRAKE 14 LED controller
(1) RX Pass-Thru
(1) 2-Channel RX Plug
(2) zip ties & bases

Specs:
DIMENSIONS: 1.65" x 1.0" x 0.25"

INPUT VOLTAGE: 3.6-7.4V [6V Optimal]

TYP OUTPUT CURRENT (per LED channel): 20-30mA

Controller pins can be directly soldered to for DIY projects. Use heat shrink to insulate each pin.

*Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.

*DO NOT look directly into beam.