Hot Racing TRXF9510 Steel Helical Diff Ring/Pinion Underdrive 10/35T : TRX4

Hot Racing steel helical spiral Underdrive 35T/10T gear set for 1/10 Traxxas TRX-4
FEATURES:
- Precision machined helical spiral cut gears offer inherently greater strength and smooth operation than the factory Straight cut bevel gears
- High carbon steel construction
- Less vibration, less noise, less wear then stock straight cut bevel gears
- 35T/10T provides 9% overdrive (vs stock 34T/11T) increases the wheel speed and is commonly used in the front end for digs
- Works on front or rear. Use cases are typically front and rear at the same time, or Rear only to increase front digs
YOU WILL RECEIVE:
- One (1) 35 tooth spiral cut ring gear
- One (1) 10 tooth spiral cut pinion gear
REQUIREMENTS:
- Installation following kit manual
- Medium threadlock (e. g. blue Loctite) if screws are threaded into metal
- Hot Racing SPL10G05 high temp grease recommended
COMMENTS:
- Replaces TRA8288
Option - overdrive the front axle, and underdrive the rear axle.
Combinations One. TRXF312 in the front and TRXF9411 in the rear.
Combinstion Two. TRXF9411 in the front and TRXF9510 in the rear.
Combinstion Three TRXF312 in the front and TRXF35810 in the rear.