Digitrax
Digitrax UP6Z LocoNet Universal Panel and 3 Amp Voltage Reducer Z Scale
(No reviews yet)
Write a Review
- SKU:
- UP6Z
- UPC:
- 652667110082
- Condition:
- New
Description
LocoNet Universal Panel and 3 Amp Z Scale Voltage Reducer
6 LocoNet Jacks for use with all scales
Reduces track voltage by 4 or 6 volts at 3 amps for safer Z Scale locomotive opreration with Digitrax equipment
Related Products
Related Products
Digitrax UP7 LocoNet Universal Panel
Digitrax
$15.99
Plug and Play Universal fascia panel supporting LocoNet.Two RJ12 front panel Throttle jacks.Three RJ12 rear pass-through LocoNet jacksSupports throttle charging.Fully connectorized installation.2mm...
UP7
Sold Out
Digitrax UP5 LocoNet Universal Interconnect Panel
Digitrax
$16.99
Add more connections to your LocoNet system.
UP5 Simplifies hook-up, maintenance & troubleshooting of LocoNet, add a few to make traditional tethered walk-around operation a snap.
UP5
Digitrax LNWI LocoNet WiFi Interface
Digitrax
$67.99
The LNWI allows you to connect compatible WiFi devices to LocoNet and run trains using compatible throttle apps. The apps available can be downloaded from this page.Wi-Fi interface to a Digitrax...
LNWI
Digitrax LNC501 50’ LocoNet Cable
Digitrax
$23.99
LocoNet Layout Wiring Made Simple!Pre-made, pre-tested 50 foot LocoNet cable.Use on any LocoNet Layout.Use for long runs or divide into custom lengths using LocoNet Cable Maker Kit & RJ12 Plugs...
LNC501
Sold Out
Digitrax LNRP Xtra LocoNet Repeater Module
Digitrax
$59.99
The LNRP LocoNet Repeater Module Isolates and Protects LocoNet Layouts, it allows for greater expansion of the LocoNet system on large installations. If a wiring or signal problems occur on any...
LNRP Xtra
Digitrax LT1 Tester for Decoders & LocoNet Cables
Digitrax
$6.49
The LT1 is included with all Digitrax Starter Sets.
It consists of a harness with 6 conductor Telco type wire with a male plug, a tester with a female 6 conductor jack, and a 100 Ohm 2...
LT1
Digitrax LNCMK LocoNet Cable Maker Kit
Digitrax
$49.99
Everything you need to make LocoNet Cables for your layout:
Crimper tool for cutting cables to length and attaching plugs to cable ends
LT1 LocoNet Tester for t
LNCMK
Sold Out
Digitrax DCS240 LocoNet Advanced Command Station
Digitrax
$324.99
The DCS240 Advanced Command Station lets your LocoNet® System run up to 400 locos and 400 throttles. Full read/write programming, route capability, USB connectivity, and separate programming output...
DCS240
Digitrax DCS240+ LocoNet Advanced Command Station
Digitrax
$324.99
Supports up to 400 locomotives and throttles.On-board USB port.Three RJ12 LocoNet portsSupports SoundFX and sound decoder programming using Digitrax SoundLoader app over USB.5amp/8amp Booster with...
DCS240+