Traxxas

INCLUDES: (1) Fiber-reinforced plastic front skid plate (1) Fiber-reinforced plastic rear skid plate (1) Fiberglass tranny spacer plate

.

FEATURES: Black nylon construction INCLUDES: One tank box REQUIRES: Nothing. This is a direct replacement part. SPECS: Length: 88mm (3.47") Width: 101mm (3.98") Height: 28mm (1.10")

FEATURES: Grey nylon construction INCLUDES: One tank box REQUIRES: Installation on the vehicle SPECS: Length: 88mm (3.47") Width: 101mm (3.98") Height: 28mm (1.10")

FEATURES: Holds fuel tank and throttle servo in place between chassis and upper plate INCLUDES: Fuel Tank Box and Servo Mount

FEATURES: Blue anodized Light weight aluminum INCLUDES: One front pulley shaft REQUIRES: Assembly onto the kit. SPECS: Length: 74mm (2.91") Diameter: 5mm (0.20") COMMENTS: This is mounted in the middle of the chassis and two pulleys ride on it.

.

FEATURES: Replaces damaged pivot ball aluminum caps. Constructed of aluminum. INCLUDES: Four pivot ball aluminum caps for the Traxxas T-Maxx. REQUIRES: Threading two caps into each axle carrier (4932) to hold the pivot balls (4933) in place.

FEATURES: Stock aluminum steering bellcranks. Steering link is steel and rods ends are plastic. INCLUDES: Two bellcrank posts One 3x25mm steering link threaded rod with rod ends REQUIRES: Placing bellcranks on posts and attaching posts to chassis...

Wheelie bar mount (1)

FEATURES: Plastic construction Black in color Rubber type boot INCLUDES: One shift fork shaft Two shift fork pads One rubber boot REQUIRES: Assembly onto the kit COMMENTS: This is a direct replacement part.

FEATURES: Replaces stock output shafts, constructed of steel. Spacer is made of plastic. INCLUDES: One output shaft and spacer REQUIRES: Installing shaft in gearbox between the clutch bell and output gear and placing spacer between the output gear and...