Traxxas

These pivot balls are installed through the upper and lower suspension arms and axle carriers and allow camber adjustment of the wheels. FEATURES: Replace stock pivot balls with these hardened heavy duty versions. Constructed of 7075 T-6 aluminum...

FEATURES: Replaces stock plastic bumpers. Constructed of molded silver colored plastic. INCLUDES: One dual-tube front bumper One dual-tube rear bumper REQUIRES: Fastening each bumper to the bumper mounts (4936) with four 3x12mm buttonhead cap screws (not...

FEATURES: Skidplate is constructed of high impact molded black plastic. Front of skidplate kicks up at about 45 degrees to shield the differential from crash damage or hard landings from jumps. Stainless steel mounting plate provides rigid mounting...

FEATURES: Attaches to and protects chassis and supports the front bulkhead Skidplate is gray in color INCLUDES: Skidplate and stainless steel plate REQUIRES: Installing on chassis with four 3x12mm countersunk machine screws (not included, use...

FEATURES: Replaces damaged rear skidplates. Constructed of black plastic. INCLUDES: One rear skidplate. REQUIRES: Bolting to bottom of chassis using three 3x10mm countersunk machine screws (not included).

FEATURES: Attaches to and protects chassis and supports the rear bulkhead Skidplate is gray in colorINCLUDES: Skidplate and stainless steel plateREQUIRES: Installing on chassis with four 3x12mm countersunk machine screws (not included, use 2552)COMMENTS:...

FEATURES: Durable steel construction INCLUDES: Eight pins REQUIRES: Assembly onto T/E-Maxx SPECS: Length: 65.3mm (2.57") Diameter: 3.2mm (.13") COMMENTS: These are enough hinge pins for the entire vehicle.

FEATURES: Attaches to and protects chassis and transmission Skidplate is gray in color Nylon construction INCLUDES: One Skidplate REQUIRES: Installing on chassis  

FEATURES: Replaces damaged or worn 2-speed drive gears Gears are constructed of plastic and pre-installed on steel shaft INCLUDES: One 17 and 22 tooth drive gear for the Traxxas T-Maxx One slipper shaft One C-clip REQUIRES: Opening gearbox and installing...

FEATURES: Fits first generation T-Maxx transmission without Optidrive Steel shaft with plastic gear 22T and 17T gears Pre-assembled on shaft INCLUDES: One transmission input shaft REQUIRES: Installation into gearbox SPECS: Length: 2.20" (56mm) Shaft...

FEATURES: Replaces damaged or worn primary gears Constructed of plastic INCLUDES: One 28 tooth forward and one 22 tooth reverse gear One 2x9.8mm steel drive pin One 5x10x0.5mm washer REQUIRES: Diassembly of gearbox and installing primary gears on to...

FEATURES: Stainless Construction Blue Rubber Sealed INCLUDES: Two 8mm x 16mm Rubber Sealed Bearings REQUIRES: Assembly onto Vehicle SPECS: Inner Diameter: 8mm (0.31") Outer Diameter: 16mm (0.62") Thickness: 5mm (0.19")